Back to Products

VSD Series-Polyurethane Idler Wheel

Idler wheels with Samflex polyurethane tread

Tread Encapsulation Hardness

75 Shore A
Protect the ground/walking noise

Very good
Rolling resistance

Very good
Wear resistance capacity

Very good

Introduction
Specification
Faq
More Products

Introduction

Tread: High-quality polyurethane elastomer cast through chemical reaction, with a hardness of 75±3 Shore A, providing excellent floor protection, low noise operation, low rolling resistance, high resistance to cuts and tears, non-marking, non-staining, and excellent adhesion to the wheel hub.

Wheel Hub: Available in 45# steel, cast iron, die-cast aluminum alloy, stainless steel, and other metal materials depending on operating conditions; surface treatments include painting, phosphating, galvanizing, and Dacromet coating.

Other Characteristics: Resistant to various corrosive substances; operating temperature: -30°C to +70°C, short-term up to +90°C, load capacity decreases above +40°C.

Specification

Single Wheel	Wheel Diameter (D) mm	Wheel Width (T2) mm	Load Capacity at 4km/h (kg)	Load Capacity at 10km/h (kg)	Number of Mounting Holes	Mounting Hole Diameter	Center Hole Diameter (d)mm	PCD (mm)
VSD 100/40	100	40	300	/	Customization Acceptable
VSD 125/40	125	40	350	/	Customization Acceptable
VSD 150/50	150	50	450	180	Customization Acceptable
VSD 180/50	180	50	650	240	Customization Acceptable
VSD 200/50	200	50	700	300	Customization Acceptable
VSD 250/50	250	50	850	320	Customization Acceptable
VSD 300/60	300	60	1100	450	Customization Acceptable
Other sizes are available upon request